Small marine actuator for Open-Close and modulating applications. Conventional motor drive, 500-10000 in. lbs., Mid Range marine actuator for Open-Close and modulating applications. Conventional motor drive, 2000-50000 in. lbs.
Designed to MIL-Spec DOD-V-24657 (SH) and the marine environment.
- Position limit switches, individually adjustable
- OPEN and CLOSE torque limit switches
- Differential drive, low effort side mounted handwheel
- Mechanical position indicator located near the handwheel and on top
- Mechanical stops for quarter-turn applications, adjustable from 85 to 95 degrees
- Integral mechanical reversing controller with valve logic available
- Thermal sensors and monitor module available
The Nu-Torque MS Series actuators have been designed to meet the requirements of the MIL-Spec DOD-V-24657 (SH) and the marine environment. Cast ductile iron or silicon bronze housings, bronze and steel gears, shafts and hardware resist the marine corrosion and are also the ideal choice for applications requiring low magnetic components. MS actuator motors used are built to MIL-M-17059 or MIL-M-17060 to provide extended life under the worst shipboard conditions.
The MS Series actuators are compact and durable reducing the stress on smaller valves where the Navy High Shock and Vibration qualification is required.
Options
- Local controls (pushbuttons and lights — local/remote switch)
- PROFIBUS,
- ModBus® serial communication
- Right angle gearbox for limited overhead locations
Actuator Specifications: |
Multi-Turn |
|
Model No. |
MS_Q |
Housing |
Cast Ductile Iron, Silicon Bronze |
Hardware |
Corrosion Resistant |
Handwheel |
3” to 6" Spinner |
Magnetic Permeability |
Less than 2.0 Available |
Switches |
250 VAC, 10 AMP |
Motor Voltage |
115, VAC, Single Phase, 60 Hz
440-480 VAC, 3 Phase, 60 Hz |
Reduction Ratio |
5:1, 15:1, 25:1, 36:1 & 45:1 |
Output Torque |
250-30,000 Inch Lbs. |
Output Speed |
15 to 60 Seconds/90 Degrees |
Weight |
48-105 Lbs. |
The data and specifications in this bulletin are for information purposes only. Consult your Nu-Torque representative for specific data. |